Multifunction Devices


February 11, 2019

Insert a floppy disk, click the Start button, click My Computer, and then double-click the floppy drive icon. If the computer is plugged into a power strip, ensure that the power strip is plugged into an electrical outlet and that the power strip is turned on. Confirm that the computer has sufficient memory to run your programs. For a parallel printer, ensure that the Print to the following port s: Then enter system setup and go to the Integrated Devices option settings.

Uploader: Fenrijas
Date Added: 2 February 2009
File Size: 46.93 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 90739
Price: Free* [*Free Regsitration Required]

If the computer does not respond to a keystroke or the mouse, press the power button for at least 8 to 10 seconds until the computer turns off. Click the Start button and click Control Panel. Ensure that the cables are properly connected to the system board from drll hard drive, CD drive, and DVD drive.

Turn your computer off, unplug it from the electrical outlet, and then remove all but one of the cards. Reseat the power cable into both the power connector on the back of the computer and the electrical outlet. Close the computer cover, reconnect the computer and modfm to electrical outlets, and then turn them on. You will not receive any additional items, components, or instructions with your package. Power extension cables Keyboard and mouse extension cables Too many devices on a power strip Multiple power strips connected to the same electrical outlet Printer Problems NOTE: If you have one memory module installed, reinstall it and restart the computer.


Dell Optiplex GX MACI Rev Modem AJP Macsystem | eBay

See the software documentation for minimum memory requirements. It is normal for monitor cable connectors to have missing pins. Exit system setup and restart the computer. Reinstall all memory modules and restart the computer.

After the computer shuts down, press the power button to restart the computer. See the monitor documentation for troubleshooting procedures.

Do not attempt to clean drive heads with a swab. Remove and then reinstall the memory modules.

See the speaker documentation for diagnostics instructions. If the battery still does not work properly, contact Dell.

i want optiplex gx270 audio video and modem drivers for windows vista?

Enter system setup and correct the Date and Time options. If your primary hard drive is connected to a drive controller card and not to one of the system board IDE connectors, leave the drive controller card installed in the computer. Also, check the diagnostic lights to see if the specific problem is identified. Then press the power button again to turn on the computer.


If the drive access light turns on, try a different disk. See your operating system documentation for information on running these utilities. Enter system setup and ensure that the boot sequence information is correct.

Insert a floppy disk, type dir a: Before you begin any of the procedures in this section, follow the steps in ” Safety Instructions. The jack has delk a green label or a connector-shaped icon next to it. Memory not being properly identified or used.

For a parallel printer, ensure that the Print to the following port s: If the power light is lit or blinking, the monitor has power. One possible beep code code consists of one beep, a burst of three beeps, and then one beep. Verify that the memory modules that you are installing are compatible with your computer.

When the computer starts normally, the patterns or codes on the lights change as the boot process completes.